Dimensions - d (inside diameter) | 30mm |
---|
SKF Four lip seal kit for use with SNL507-606 plummer block
SKF TSN-L Four-lip seals
SKF SNL housing seals are the first barrier against contamination. The four-lip seals replace the former double-lip seals. The four-lip seals are more effective than the double-lip and generate less friction, which enables higher shaft speeds. For highly contaminated environments, SKF recommends the three-barrier solution. This cost-effective sealing solution can have a significant impact on bearing service life as contaminants have to pass through three barriers to reach the bearing. When ordering, please note that one item (seal pack) contains two seals (four halves).
With shaft speeds continuously increasing, there was a need for a sealing solution that could accommodate higher speeds with the same high level of performance that the SKF double-lip seal could provide at lower speeds. To meet that need SKF developed a robust, easy to mount four-lip seal that can accommodate peripheral speeds up to 13 m/s. This four-lip seal is made from a specially formulated thermoplastic elastomer. Operating temperature range for the seal is between -40 and +100 degrees C. Each package of four-lip seals contains two seals.
Dimensions
da 30 mm Shaft diameter
Dc 54.5 mm Diameter of seal groove
B 12.5 mm Width
Properties
Accessory type Housing seal
Sealing type Four-lip
Material Thermoplastic polyester elastomer (TPE)